MotorRunning = tSpeed(speed, acceleration, WPMControl::DIR_CW) direction could be DIR_CW (clockwise) or DIR_CCW (counter-clockwise) acceleration number higher the sooner the motor reaches target speed.
start motor with provided speed, acceleration rate and direction (DIR_CW or DIR_CCW)
tell WPMControl to use initialized serial Serial.begin(WPMCONTROL_SERIAL_BAUD, WPMCONTROL_SERIAL_CFG) could be hardware serial or software searial. Sometimes you will need the 12 digit number, which is usually prefixed with 12NC in front of it, on some parts you will need both of these numbers, it might not be listed on the website because it is serial number dependent.// initialize serial stream. The machine will automatically exit the diagnostic/test mode sequenceĪfter the test sequence if you find that you do need a part for your washing machine, you will need the full model number of the ID Plate, which you can normally find on the inside of the door frame or in the rear of the machine. Once the machine as entered the test mode sequence you will see a series of flashing lights:ġ - The machine starts by checking if the door lock is working correctly Ģ - Then goes to a fill sequence where it will test each water valve individually – it will start filling the right hand compartment in the soap drawer, then switches over to the other water valve on the left hand compartment, after this, both water valves will be activated (fills all three compartments, including the fabric conditioner in the middle) ģ - Next it will test right hand rotation of the motor (clockwise), and left hand rotation of the motor (anticlockwise), while it´s also testing the NTC sensor and the heater element
NOTE: this doesn´t always go in first time, so as soon as you turn the dial from the OFF position to the DRAIN position, you have 5 seconds to press the RESET button 4 times. To enter the diagnostic/test mode sequence, you need to turn the dial to the DRAIN position, which is at eleven o´clock then you must press the RESET button four times, within five seconds to enter the test mode sequence.
0 kommentar(er)
